P2C6A
Drive Motor A Phase X Current Low
P2C6A means that too little current is seen in phase X of drive motor A while the inverter is driving it, which typically points to an open phase or a dead sensor. No carmaker documents the code publicly. GM's U/V/W counterpart shows how such a check works: in the 2016 Volt, the motor control processor samples each phase while the rotor sits within 30 degrees of that phase axis, with the inverter in normal PWM above 50 V and more than 900 A2 commanded; a peak below 9 A for 0.4 s within 0.6 s sets the code as Type A, MIL after one trip. In a dual-winding motor with a second X/Y/Z set, as in a Mitsubishi Electric patent, the same test would apply to phase X. P2C69 is the general X code, P2C6B the high side, P2C6D and P2C70 the low faults of Y and Z.
Possible causes
- Phase X lead or terminal open or high-resistance between inverter and motor high
- Phase X current sensor reading near zero (sensor or its supply failed) medium
- Switching leg for phase X in the inverter not conducting medium
- Open winding of phase X inside drive motor A low
Symptoms
- Hybrid or drive system warning and MIL on
- Noticeably weaker or jerky electric drive, or drive disabled
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2C6A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.