P2C66
Hybrid/EV Electronics Coolant Pump A Underspeed
P2C66 reports that pump A of the electronics cooling loop, which carries heat away from inverter, DC/DC converter and often the on-board charger or drive motor, turns slower than requested. Pumps of this kind report their actual speed, and the controller compares it with the target. No manufacturer publicly documents P2C66. Ford's 2024 summary uses the same fault type, under-speed (B2), for engine coolant pump A, monitored continuously over 5 seconds above 11 V. GM's 2016 Volt judges pump A of its power electronics loop differently, as P0CEA, when coolant and charger temperatures drift apart. Worn bearings, sludge or debris, low supply voltage and partial air are typical. Expect reduced drive power or slower charging. Overspeed is P2C67, a stalled pump P2C68.
Possible causes
- Worn bearings or a sluggish impeller high
- Debris or sludge in the pump or a restricted loop medium
- Low supply voltage from fuse, relay or ground faults medium
- Air pockets after a coolant service low
Symptoms
- Hybrid/EV system warning and check engine light
- Reduced drive power or slower charging
- Electronics temperature rises faster than usual
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2C66
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.