OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C65

O2 Sensor Out of Range During Deceleration Bank 1 Sensor 3

P2C65 is the overrun plausibility check for the third oxygen sensor of bank 1: with fuel cut on deceleration the exhaust is close to fresh air, so the reading must land inside a known window. GM's 3.0L Duramax runs this test for sensor 1 under P2297, where table 25OBDG04B compares the measured O2 value with an estimate in overrun and flags a gap above 4 or below -3.25 percent (Type B). For sensor 3, NOx sensor 3 behind the second catalyst, GM publishes no threshold, but PIT5751C and bulletin 21-NA-149 list P2C65 together with P2C63/P2C64 on 2020-21 trucks and SUVs with the 3.0L LM2, where a chafed engine harness was the cause. CARB accepts a check during fuel shut-off where full rear-sensor monitoring is not feasible. The sensor 2 code is P232F, sensor 1 P2297.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 65

Possible causes

  • Third exhaust sensor aged or drifting (wrong value in fresh air) high
  • Exhaust leak ahead of sensor 3 distorting the overrun reading medium
  • Damaged sensor wiring or chafed engine harness (GM 3.0L LM2) medium
  • Leaking injector or model error disturbing the comparison in overrun low

Symptoms

  • MIL on, usually without noticeable driving change
  • Possibly stored together with other sensor 3 or NOx sensor codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C65

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication