P2C64
O2 Sensor Pumping Current Trim Circuit High Bank 1 Sensor 3
P2C64 is the high-side partner of P2C63: the oxygen reading attributed to sensor 3 of bank 1 climbs above what the probe can physically deliver. On GM's 3.0L Duramax diesel the value comes from NOx sensor 3 behind the second catalyst, and table 25OBDG04B sets the code once that O2 reading exceeds 29 percent, clearly more than the roughly 21 percent of fresh air, in 100 of 200 samples under the same enable conditions as the low check; Type B, MIL after two trips. Such a figure hints at a signal fault in the sensor or its wiring rather than real exhaust oxygen. The harness bulletins PIT5751C and 21-NA-149 for 2020-21 GM models with the 3.0L LM2 list P2C64 as well. P2C62 is the open circuit, P23AF the NOx circuit high code of the same sensor.
Possible causes
- Third exhaust sensor (on GM diesels NOx sensor 3) delivering an implausibly high O2 value high
- Engine harness chafed or shorted (GM 3.0L LM2, PIT5751C) medium
- Moisture or corrosion in the sensor connector low
Symptoms
- MIL on after two trips
- Further NOx sensor or aftertreatment codes stored
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C64
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.