OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C63

O2 Sensor Pumping Current Trim Circuit Low Bank 1 Sensor 3

P2C63 reports that the oxygen value from the third exhaust sensor of bank 1 has dropped below its physically possible minimum. Despite the trim wording, GM uses it on the 3.0L Duramax diesel for the O2 signal of NOx sensor 3, which sits behind the second catalyst: table 25OBDG04B (2025) fails a reading under -6 percent in 100 of 200 samples on a 25 ms task, with the engine running, supply above 11 V and the sensor ready; Type B, MIL after two trips. GM's PIT5751C and bulletin 21-NA-149 name P2C63 among many codes on 2020-21 Silverado, Sierra, Tahoe, Yukon and Escalade with the 3.0L LM2; the cause was an engine harness rubbed through above the generator or shorted against the clamp of the crankcase-pressure-regulator hose. P2C64 is the high side, P23AE the NOx circuit low code of this sensor.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 63

Possible causes

  • Engine harness chafed or shorted (GM 3.0L LM2 - at the generator or the crankcase pressure regulator clamp) high
  • Third exhaust sensor (on GM diesels NOx sensor 3) reporting an implausibly low O2 value medium
  • Corroded or loose sensor connector low

Symptoms

  • MIL on after two trips
  • On the GM LM2 often many other codes, rough running or blown fuses when the harness is damaged
  • Aftertreatment monitors not completing

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C63

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication