OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C62

O2 Sensor Pumping Current Trim Circuit/Open Bank 1 Sensor 3

P2C62 points to an open trim circuit at the third oxygen probe of bank 1. Wide-band probes such as Bosch's LSU 4.9 carry a trimming resistor in the connector on a pin of its own (RT/IA) that sets each probe's characteristic; the engine module reads it to scale the pump current, so with the lead broken the signal still moves but with the wrong gain. A third probe sits behind a second catalyst, on diesels typically after the SCR stage. No carmaker documents P2C62 publicly: GM's 3.0L Duramax tables and bulletins use only P2C63, P2C64 and P2C65 for sensor 3. CARB requires circuit continuity checks on oxygen and air-fuel sensors. The front and middle analogues are P2626 and P22B5; low and high faults of this probe are P2C63/P2C64.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 62

Possible causes

  • Trim line broken or terminal pushed back in the probe connector high
  • Moisture or corrosion in the connector of the rear probe medium
  • Trimming resistor in the probe connector open (probe replacement) low

Symptoms

  • MIL on, usually without noticeable driving change
  • Catalyst or aftertreatment monitors not completing

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C62

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication