OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C61

Cylinder 8 Fuel Injector B Offset Learning At Max Limit

P2C61 closes the series: injector B of cylinder 8 has driven its learned offset into the ceiling, so this valve stays short of fuel despite the longest correction allowed. Because a weak supply pump or low rail pressure would starve every injector of the same set, a Max code on a single cylinder narrows the search to that valve, its wiring or the air path of that cylinder. A lean system B trim on bank 2 (P2BF2) fits the picture on most V8 numbering schemes. Ford's published OBD summaries for the V8 with both injection types omit P2C61, and no other manufacturer documents it; Volvo's bulletin for the Max codes stops at cylinder 4. California's OBD rule (CARB 1968.2, section (e)(6.2.2)) makes an adaptation without remaining range a reportable fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 61

Possible causes

  • Varnish or deposits in injector B of cylinder 8, slow opening high
  • Corroded or loose connector, chafed wire or voltage drop at this injector medium
  • Old adaptation values left at the limit after a repair or software change medium
  • Air leak at the intake runner of cylinder 8 (only where the learn uses exhaust oxygen) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Possibly uneven idle or lean misfire on cylinder 8

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C61

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication