OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C60

Cylinder 8 Fuel Injector B Offset Learning At Min Limit

P2C60 is the minimum-limit code for injector B on cylinder 8, the last cylinder of a V8 and the end of this code series. Its A-side twin P02DA is documented by GM for the L5P diesel and by Land Rover for a 5.0 V8, but the B version has no public manufacturer source at all. The physics are the same as on the other cylinders: the learned correction has shortened the pulse to the floor because this valve keeps overdelivering. On a V8 a dripping injector on cylinder 8 often shows up as a rough first few seconds after a hot start, sometimes with a misfire record for cylinder 8 (P0308). Under both Ford and GM numbering it sits on bank 2. CARB 1968.2 (e)(6.2.2) requires the check.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 60

Possible causes

  • Injector B of cylinder 8 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Old learned values not reset after injector or software work medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 8
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C60

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication