P2C5D
Cylinder 6 Fuel Injector B Offset Learning At Max Limit
P2C5D says injector B of cylinder 6 needs the largest learned offset allowed. Because the offset depends on how quickly the driver can energise the coil, electrical causes deserve the first look: a corroded or loose connector, chafed wiring or a supply voltage that sags on that injector lengthen the real opening delay. If a circuit code for the same valve (P21D4) is present, that comes first. Mechanical causes are deposits or a sticking pintle. On six- and eight-cylinder engines with port plus direct injection this valve is often under the intake manifold, which makes access costly. No maker documents P2C5D publicly; the only bulletin for the family, Volvo's TJ 36016, stops at cylinder 4. CARB 1968.2 (e)(6.2.2) applies.
Possible causes
- Varnish or deposits in injector B of cylinder 6, slow opening high
- Corroded or loose connector, chafed wire or voltage drop at this injector medium
- Old adaptation values left at the limit after a repair or software change medium
- Air leak at the intake runner of cylinder 6 (only where the learn uses exhaust oxygen) low
Symptoms
- Check engine light
- Often nothing else noticeable
- Possibly uneven idle or lean misfire on cylinder 6
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C5D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.