OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C5C

Cylinder 6 Fuel Injector B Offset Learning At Min Limit

P2C5C reports that the injector B offset for cylinder 6 has been learned down to its minimum. In practice the most telling check is the learned value itself: a scan tool that shows the offsets of all B injectors makes one outlier obvious. For an overdelivering valve a pressure-hold test of the rail after shut-off helps, since a dripping injector lets pressure fall faster and may leave a fuel smell or a long hot start. On in-line sixes cylinder 6 is the last one on the rail; on V6 engines its bank depends on the maker's numbering. No manufacturer documents P2C5C publicly; Volvo's injector B bulletin stops at cylinder 4. Under section (e)(6.2.2) of CARB's 13 CCR 1968.2 the exhausted correction counts as a fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 5C

Possible causes

  • Injector B of cylinder 6 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Old learned values not reset after injector or software work medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 6
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C5C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication