OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C5A

Cylinder 5 Fuel Injector B Offset Learning At Min Limit

P2C5A can only occur on engines with at least five cylinders and indicates that cylinder 5's injector B has had its learned offset pulled down to the lower bound. The control has removed as much opening time as it may, yet the cylinder still gets more fuel than intended from this valve. On V engines with Ford numbering cylinder 5 opens bank 2; GM numbering puts it on bank 1. Candidates are a dripping valve, a part with too high a flow rating after a repair, or fuel pressure that the model underestimates. No manufacturer documents P2C5A publicly, and Volvo's bulletin for this code family covers only cylinders 1 to 4. CARB's rule 1968.2 (e)(6.2.2) calls for detection once an adaptive correction has used up its range.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 5A

Possible causes

  • Injector B of cylinder 5 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Old learned values not reset after injector or software work medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 5
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C5A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication