OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C58

Cylinder 4 Fuel Injector B Offset Learning At Min Limit

P2C58 marks the minimum limit of the injector B offset on cylinder 4. Useful for diagnosis is a look at the A injector of the same cylinder: if P02D2 is stored as well, both valves seem to overdeliver, which points to something both learns share, such as the measurement or the cylinder itself, rather than to one injector. A lone P2C58 points to injector B, for example a seat that drips after shut-off and makes hot restarts long or the first seconds rough. On a four-cylinder engine this is the last cylinder of the row. No manufacturer publishes this code; Volvo's Technical Journal 36016 lists only the opposite code P2C59 for cylinder 4. Detection of an adaptation at its limit is demanded by CARB 1968.2 (e)(6.2.2).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 58

Possible causes

  • Injector B of cylinder 4 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Learned values or engine software not up to date (Volvo pairs an update with an adaptation reset for the related Max codes) medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 4
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C58

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication