OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C56

Cylinder 3 Fuel Injector B Offset Learning At Min Limit

P2C56 is set once injector B of cylinder 3 has its learned offset stuck at the minimum. How such a value is learned is shown in Ford patents for engines that combine both injection types: with the lift pump switched off, the port injectors fire one cylinder at a time while the others run on direct injection, and how far the low-pressure rail sags after every pulse shows how much fuel that injector really released. If cylinder 3 keeps releasing more than expected, the correction moves down until it reaches the floor. Typical sources are a leaking seat or an internal leak that adds fuel between pulses. No manufacturer documents this code publicly; it also exists on three-cylinder engines. CARB 1968.2 (e)(6.2.2) makes an exhausted adaptation a fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 56

Possible causes

  • Injector B of cylinder 3 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Learned values or engine software not up to date (Volvo pairs an update with an adaptation reset for the related Max codes) medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 3
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C56

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication