OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C54

Cylinder 2 Fuel Injector B Offset Learning At Min Limit

P2C54 concerns injector B of cylinder 2 and the lower limit of its learned offset. Reaching the floor means the control had to keep cutting the opening time because the injector delivers too much, typically at the short pulses where dead time dominates. Plausible reasons are a seat that drips after closing, a replacement injector of a different flow class, or a rail pressure higher than the model assumes. Whether cylinder 2 sits on bank 1 or bank 2 depends on the numbering: in-line engines have one bank, GM V engines put even cylinders on bank 2, Ford V engines count cylinders 1 to 4 on bank 1. No maker documents P2C54 publicly, and Volvo's bulletin for this injector family lists only the Max code P2C55. The legal basis is CARB 1968.2 (e)(6.2.2).

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 54

Possible causes

  • Injector B of cylinder 2 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Learned values or engine software not up to date (Volvo pairs an update with an adaptation reset for the related Max codes) medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 2
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C54

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication