OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C52

Cylinder 1 Fuel Injector B Offset Learning At Min Limit

Engines with two injectors per cylinder call the second one injector B; with port plus direct injection that is usually one of the two sets, but which one is the maker's choice. For every B injector the engine control learns an offset, a correction for the dead time between the electrical command and the start of real fuel flow. P2C52 says this correction for cylinder 1 has been pushed to its lowest permitted value: the injector already passes more fuel than its model expects, and the pulse cannot be shortened any further. CARB 13 CCR 1968.2 (e)(6.2.2) counts an adaptation that has used up its authority as a malfunction. No manufacturer publishes this exact code; Volvo's Technical Journal 36016 names only the Max partner P2C53.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 52

Possible causes

  • Injector B of cylinder 1 leaking at the seat and adding fuel after closing high
  • Replacement injector of a different flow rating or not matched to the engine software medium
  • Learned values or engine software not up to date (Volvo pairs an update with an adaptation reset for the related Max codes) medium
  • Supply pressure on this injector set higher than the model assumes (regulator) low

Symptoms

  • Check engine light
  • Often nothing else noticeable
  • Long hot start or rough first seconds, possibly misfire on cylinder 1
  • Possibly fuel smell or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C52

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication