OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C4C

Clutch Actuator Position Sensor Circuit Low

P2C4C means the signal of the clutch actuator position sensor has fallen below its valid band. Ford documents it in its gasoline OBD summaries for 2020–2023 and 2024 under Clutch Actuation Position: the check runs continuously and needs less than one second to register the fault, and in the 2024 version it is reported as base code P2C4A with failure type 11. The section sits next to the clutch pedal sensor checks used for start-stop with manual gearboxes; Ford gives no MIL statement for it. A low reading usually comes from a signal wire shorted to ground, a missing 5 V supply or a sensor that has failed internally. Because the module then cannot tell whether the clutch is open, functions that depend on it, such as stopping the engine with a gear engaged, are disabled. P2C4D covers the high side.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 4C

Possible causes

  • Signal wire shorted to ground high
  • 5 V reference supply missing or shorted medium
  • Position sensor failed internally medium

Symptoms

  • Stop-start or stop-in-gear unavailable
  • Warning lamp or message

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C4C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication