OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C4B

Clutch Actuator Position Sensor Circuit Range/Performance

P2C4B flags a clutch actuator position signal that is electrically valid but does not fit the situation, for example a reading that does not move when the actuator is commanded, or end stops that lie outside the learned window. Measuring position on the hydraulic side has its own pitfalls: Schaeffler (LuK) found on its electronic clutch management that brake fluid warming up after a drive shifted the apparent position by around 6 mm against a total travel of roughly 20 mm when the sensor sat at the master instead of the slave cylinder, and had to compensate in software. Air in the fluid acts similarly. No manufacturer publishes P2C4B; Ford only lists the low, high and correlation codes for this sensor. Expect start-stop or automated clutch functions to be limited and a relearn to be needed after repair.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 4B

Possible causes

  • Air or leakage in the clutch hydraulics high
  • Sensor drift or loose sensor mounting medium
  • Clutch end positions not relearned after service medium
  • Clutch wear moving the engagement point out of range low

Symptoms

  • Harsh or slipping clutch engagement
  • Stop-start disabled
  • Warning message about the gearbox or clutch

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C4B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication