P2C4A
Clutch Actuator Position Sensor Circuit
The clutch actuator position sensor reports how far the release mechanism of an automated or partly automated clutch has travelled, taken at the slave cylinder or inside the actuator rather than at the pedal. Typical designs are Hall sensors reading a magnet on the clutch piston. P2C4A is the general circuit fault of this sensor. Ford reports it in two ways: its 2024 OBD summary uses P2C4A as the base code behind the low and high faults P2C4C/P2C4D (failure types 11 and 12), and lists P2C4A_48 under P166F as an internal module check of the clutch actuation position, without MIL on manual gearboxes with stop in gear. Range, low, high and erratic faults have separate codes P2C4B–P2C4E. Without a valid signal the controller cannot judge clutch state, so start-stop or automated clutch functions are switched off.
Possible causes
- Damaged or corroded sensor connector near the gearbox high
- Open supply, signal or ground wire medium
- Position sensor on slave cylinder or actuator failed medium
- Control module fault (Ford internal check P166F) low
Symptoms
- Stop-start or stop-in-gear disabled
- Warning lamp or message
- Automated clutch may refuse to engage or drive off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2C4A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.