OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C46

Battery Isolation/Voltage Stabilization Control Circuit High

P2C46 is the opposite of P2C45: the control line of the battery isolation or voltage stabilization switch sits higher than expected, which points to a short to battery voltage, or, on a low-side driven relay, to an open circuit that leaves the sense input floating high. The consequence can be worse than with a low signal, because a switch that cannot be commanded may stay closed during restarts, so the supply dip the stage is meant to block reaches the electronics again; Ford's start-stop patent describes the main battery sagging to roughly 5–7 V while cranking. No manufacturer documents P2C46 openly, so the exact threshold is calibration-specific. Check for wires pinched against B+ cables, then for an open circuit, before replacing the isolator.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 46

Possible causes

  • Control wire shorted to battery positive high
  • Open circuit with low-side driver (input pulled high) medium
  • Isolator internally defective medium
  • Control module input or driver fault low

Symptoms

  • Fault indicator on
  • Stop-start disabled
  • Screens or radio may reset when the engine restarts

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C46

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication