OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C45

Battery Isolation/Voltage Stabilization Control Circuit Low

P2C45 is stored when the line that commands the battery isolation or voltage stabilization switch reads lower than its commanded state allows, the classic picture of a short to ground or, with a high-side driver, an open coil pulling the sense voltage down. The switch exists so that the starter can draw its peak current from one battery while sensitive loads stay on a separate, stable supply; Ford's start-stop patent describes this split and notes that relays used for it wear and suffer from contact oxide. No manufacturer publishes P2C45 itself; Ford's PowerBoost F-150 cases are filed under P2C44. A chafed harness near the battery tray or a water-damaged connector is the usual find. Stop-start or engine pull-up support is typically blocked until the short is repaired.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 45

Possible causes

  • Control wire chafed through and shorted to ground high
  • Corroded or water-damaged connector near the battery medium
  • Isolator relay coil shorted internally medium

Symptoms

  • Fault indicator on
  • Stop-start function unavailable
  • Possible blown fuse in the control circuit

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C45

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication