P2C43
Battery Isolation/Voltage Stabilization Control Circuit
Some vehicles split their 12 V system with a switch so that a heavy starter load, typically an automatic restart, cannot pull the supply of control units and displays down. A Ford patent on start-stop cars puts that dip at roughly 5 to 7 V without such separation. The switch, a relay or semiconductor isolator, is commanded by a control module, and P2C43 is the general fault of this command line, usually an open circuit or a driver that sees no plausible load. No manufacturer documents P2C43 publicly; the only published case in this family is Ford's PowerBoost F-150 with an auxiliary battery isolator, which stores the performance code P2C44. Low, high and intermittent faults have their own codes P2C45 to P2C47. Expect auto stop-start or electric assist to be held back and a fault lamp; driving normally remains possible.
Possible causes
- Open control wire or loose connector at the isolator high
- Isolator relay coil or electronic switch failed medium
- Poor ground connection of the isolator circuit medium
- Output driver in the control module defective low
Symptoms
- Warning lamp or powertrain fault indicator on
- Automatic stop-start no longer stops the engine
- Radio or displays may reboot during engine starts
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C43
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.