P2C40
Fan 4 Control Circuit High
P2C40 states that fan control output 4 is held at too high a level: the line has contact with battery voltage, or the driver cannot pull it down when it should. In Saab's 2011 9-5 the counterpart relay codes P0692, P0694 and P0696 stand for a relay control wire shorted to a voltage source, and the manual adds that a stage stuck on can also occur without any stored code. No manufacturer publicly documents P2C40. Typical finds are insulation worn through against a live wire, moisture bridging two pins and a defective relay or fan module input. The fan may run without pause, even after the engine is off, or not respond at all, and a fan that keeps turning can flatten the 12 V battery. Low voltage is P2C3F, the general circuit fault P2C3E.
Possible causes
- Fan 4 control wire in contact with a battery-voltage circuit high
- Relay or fan module input failed internally medium
- Moisture bridging pins in the connector low
Symptoms
- Fan 4 runs constantly, sometimes after switch-off
- Discharged 12 V battery after standing
- Check engine light
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2C40
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.