P2C3F
Fan 4 Control Circuit Low
With P2C3F the module senses the control line of fan output 4 at too low a level, which in practice means a short to ground or, with a driver that switches to ground, a line held there by a fault downstream. Saab's 2011 9-5 workshop data define the matching codes for relays 1 to 3 (P0691, P0693, P0695) as a ground short in the relay control wiring, tested with ignition between 8 and 18 V and the engine above 400 rpm, and class them as type B with warning lamp. No manufacturer publicly documents P2C3F itself. Depending on the wiring, the short can switch fan 4 on for good or blow a fuse so it never starts. Check the insulation along the harness first, then the relay coil or module input. Circuit/open is P2C3E, high voltage P2C40.
Possible causes
- Fan 4 control wire chafed through to body or engine ground high
- Shorted relay coil or fan module input medium
- Water in the fan connector near the radiator low
Symptoms
- Fan 4 runs constantly or not at all
- Blown fan fuse
- Check engine light
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2C3F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.