OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C3E

Fan 4 Control Circuit

P2C3E reports a fault on the control circuit of a fourth fan output: the driver in the engine or fan control module sees an open line, a missing load or an error it cannot sort into low or high. What counts as fan 4 is up to the maker. Saab's GM-based 9-5 of 2011 shows that such numbers follow control outputs rather than motors: three relays switch speed stages of two fans and report P0480 to P0482, or split into short to ground and short to voltage P0691 to P0696, all type B. No manufacturer publicly documents P2C3E. A blown fuse, an open relay coil, a broken wire or a loose plug at the fan are the likely finds. Depending on layout one fan stage stays off, and the engine may run hot in slow traffic. Low and high variants are P2C3F and P2C40.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 3E

Possible causes

  • Broken wire or loose connector in the fan 4 control line high
  • Fan 4 relay coil open or relay missing medium
  • Blown fuse feeding the relay or fan module medium
  • Output driver in the control module defective low

Symptoms

  • One fan or fan stage does not run when commanded
  • Rising temperature at idle or in traffic, weaker A/C at standstill
  • Check engine light

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C3E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication