P2C3D
Cylinder Head Temperature Sensor A/B Correlation
An engine with two head temperature sensors can check one against the other: after a long soak both should read close to each other and to coolant temperature, and while running their gap should stay inside an expected band. P2C3D means sensors A and B disagree beyond that limit although neither circuit shows a fault. No manufacturer publicly documents the code or its thresholds. From 2019, phased in until 2021, CARB asks makers that use extra component temperature sensors, also where those sensors sit in different coolant circuits, to have a monitoring plan approved. Ford's 2.7 L EcoBoost bulletins show that both PCM software and a revised CHT sensor can be to blame for implausible head readings. Compare both values on a cold engine; the one far from coolant temperature is suspect.
Possible causes
- One of the two sensors has drifted out of tolerance high
- Contact resistance in one sensor circuit shifting its reading medium
- Engine control software judging the pair too tightly low
- Real temperature difference from air pocket or poor flow in one head area low
Symptoms
- Check engine light without driveability complaints
- Clearly different values for head temperature A and B after a cold start
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C3D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.