OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C3A

Cylinder Head Temperature Sensor B Circuit Low

P2C3A reports that the signal of cylinder head temperature sensor B sits below the lowest voltage the module accepts. Because these sensors are NTC thermistors, a very low voltage would stand for an impossibly hot head, so the usual reasons are a signal wire shorted to ground, water inside the plug or a sensor with an internal short. No manufacturer publicly documents this code. Ford's monitor for its first sensor shows the method: under 0.244 V for 5 seconds, checked continuously, sets the low-input code (P017C, older P1290). The ECM then has to substitute a value, and some calibrations play it safe with full fan operation or a warning. Expect a false overheat message or reduced power. High input is P2C3B, plausibility P2C39.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 3A

Possible causes

  • Signal wire of sensor B chafed through to ground high
  • Moisture or coolant in the sensor connector medium
  • Internal short in the thermistor of sensor B medium

Symptoms

  • Overheat warning or very high head temperature in live data on a cold engine
  • Cooling fans running at full speed without reason
  • Check engine light, possibly reduced engine power

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C3A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication