P2C35
Crankcase Pressure Sensor B Circuit High
P2C35 is set when the signal of crankcase pressure sensor B sits above the highest voltage the sensor can legitimately produce. That usually means an interrupted signal wire pulled up inside the module, a broken sensor ground, or a short from the signal to the 5 V supply or to battery voltage. Maserati names P2C35 in bulletin MAS002969/A, on the MY21 blow-by sensor of the F160 six and F154 eight-cylinder engines, together with P2C33/P2C34 and the A-sensor codes; besides wiring and pins it lists a faulty sensor, outdated or corrupted ECM software. Ford's analogue sensor A uses P051D above 4.56 V for 5 s as its counterpart. Because the ventilation monitor depends on this signal, the MIL lights even though the engine runs normally.
Possible causes
- Open signal wire or unplugged connector high
- Missing sensor ground (low reference) medium
- Signal shorted to 5 V reference or battery voltage medium
- Faulty sensor or outdated engine control software low
Symptoms
- MIL on
- Crankcase ventilation monitor not completed
- Usually no driveability change
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2C35
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.