OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C28

Fuel Injector Group B Supply Sense Circuit High

P2C28 is set when the sense line of the injector group B supply shows more voltage than allowed – either above the upper limit while the group is switched on, or voltage present while the module has switched the group off. Common reasons are a welded injector relay, a supply wire chafed against another powered circuit, or a sense wire shorted to battery voltage. A supply that cannot be switched off matters because the module can no longer isolate the group when it needs to protect an injector or the catalyst. No publicly accessible manufacturer document covers P2C28; it follows CARB's demand for separate high-range codes, and GM's handling of injector supply faults on the Saab 9-5 2.0T (wrong voltage for over 1 s, Type B, injector disabled) gives a comparable logic.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 28

Possible causes

  • Injector relay contacts stuck closed high
  • Sense or supply wire shorted to battery voltage medium
  • Excessive system voltage from the charging system low
  • Internal fault of the supply switch in the engine control module low

Symptoms

  • Check engine light
  • Often no noticeable change in running
  • Battery drain if the relay stays closed after switch-off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C28

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication