OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C27

Fuel Injector Group B Supply Sense Circuit Low

P2C27 reports that the voltage read back on the supply sense line of injector group B is too low while the module expects the group to be powered. In practice the feed never reaches the injectors – a blown fuse, a relay that does not close, a broken supply wire or a grounded feed – or only the sense wire itself is grounded. In the first case the cylinders of group B receive no fuel and misfire or stay dead; in the second the engine may run normally. No publicly accessible manufacturer source documents P2C27; CARB requires out-of-range low checks of such circuits. GM's direct-injection logic, documented for the Saab 9-5 2.0T, disables an injector once its supply voltage is wrong for more than 1 s and stores a Type B fault. The high case is P2C28.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 27

Possible causes

  • Blown fuse in the injector group B supply high
  • Injector relay not closing or burnt contacts medium
  • Supply or sense wire shorted to ground medium
  • Internally shorted injector pulling the group supply down low

Symptoms

  • Check engine light
  • Misfire on several cylinders, rough idle
  • Clearly reduced power or engine will not start

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C27

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication