OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C25

Exhaust Heat Exchanger Exhaust Bypass Valve A Position Sensor Circuit High

P2C25 is the counterpart of P2C24: the feedback from the position sensor of exhaust heat exchanger bypass flap A sits above the highest value a working sensor can deliver. This usually points to a signal line touching a voltage source, an interrupted sensor ground or an internal sensor fault that pulls the output toward the reference. The check is a pure range test demanded by CARB for comprehensive components and does not judge whether the flap actually moves. No manufacturer documents P2C25 publicly; the nearest cases are Ford's full hybrids, where SSM 52050 fixes P2C22/P2C23 on F-150 PowerBoost trucks with a new muffler inlet pipe, naming the bypass valve as cause. Ford's patent describes estimating the flap state from coolant temperatures instead. Expect a lit MIL and reduced heat recovery.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 25

Possible causes

  • Position signal wire shorted to a voltage source high
  • Open ground circuit of the position sensor medium
  • Position sensor in the actuator failed high medium

Symptoms

  • Check engine light
  • Cabin heater slow to warm up in winter

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C25

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication