OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C24

Exhaust Heat Exchanger Exhaust Bypass Valve A Position Sensor Circuit Low

P2C24 is stored when the position signal of exhaust heat exchanger bypass flap A drops below its permitted band. Typical reasons are a signal wire shorted to ground, an open sensor supply or an actuator whose sensor has failed low. CARB requires engine modules to check such inputs for readings outside their range and to keep separate codes for low, high and open where feasible. No manufacturer publishes P2C24 itself; Ford documents only the general circuit code P2C22 and the performance code P2C23 for the same sensor on its full hybrids, where SSM 53003 replaces the heat exchanger actuator on the F-150. An older Ford patent notes that such flaps often had no sensor at all, so the code only applies to actuators that report position. Warm-up may be slower; the MIL is expected.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 24

Possible causes

  • Position signal wire shorted to ground near the exhaust high
  • Open or missing 5 V supply to the position sensor medium
  • Position sensor inside the actuator failed low medium
  • Water in the actuator connector low

Symptoms

  • Check engine light
  • Heat recovery switched off, slower warm-up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C24

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication