OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C22

Exhaust Heat Exchanger Exhaust Bypass Valve A Position Sensor Circuit

Full hybrids with exhaust heat recovery pass hot exhaust through a coolant heat exchanger after a cold start and divert it around the exchanger with flap A once enough heat has been gathered. A sensor in the flap actuator reports the flap angle to the engine module. P2C22 is the general electrical fault of that feedback: the signal is missing or cannot be read. Ford uses it on its full hybrids. SSM 51921 ties P2C22 with P237C/P237D on the 2022–2023 Maverick 2.5L to water inside the heat exchanger, which is replaced; on 2021–2023 F-150 3.5L PowerBoost trucks SSM 52050 blames the bypass control valve and replaces the muffler inlet pipe, and SSM 53003 supplies an actuator kit. The MIL lights; P2C24/P2C25 name low and high signals, P2C23 an implausible one.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 22

Possible causes

  • Water intrusion into the heat exchanger or its actuator (Ford Maverick hybrid) high
  • Failed bypass valve actuator with integrated position sensor high
  • Corroded or loose connector at the actuator under the vehicle medium
  • Harness near the exhaust chafed or heat-damaged low

Symptoms

  • Check engine light
  • Slower engine warm-up and weaker cabin heating in cold weather
  • Engine of the hybrid runs longer before it may shut off

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2C22

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication