OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C21

Engine Oil Temperature Sensor A/B Correlation

Engines with two oil temperature sensors can check them against each other; P2C21 means sensors A and B disagree although each signal is electrically valid. GM runs up to three tests in its 2019 and 2025 tables (19OBDG03D, 25OBDG03B): after a cold soak (engine off over 540 s or 2,100 s) oil, coolant and intake air must start within 16 °C of each other; the 2025 table also expects the oil to reach 70 °C once enough air has passed; and in operation A and B may differ by no more than 15.8 °C (8 of 10 samples). Type B, MIL after two trips. GM table 23OBDG07 sets it above 15 °C between the two sump sensors, likewise on two trips. A GM patent describes the coolant/intake comparison. Single-sensor faults are P0196 (A) and P01BA (B); typical causes are a drifting sensor or corroded contacts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 21

Possible causes

  • One oil temperature sensor drifting or stuck within its range high
  • Corroded or loose contacts adding resistance on one sensor medium
  • Low oil level leaving one sensor partly uncovered low
  • Block or oil heater use skewing the cold-start comparison low

Symptoms

  • MIL after two trips
  • Oil life or oil temperature display may be wrong
  • Usually no change in driveability

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2C21

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication