OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C20

Cold Start Fuel Pressure Regulator A Exceeded Control Limits - Pressure Too High

P2C20 mirrors P2C1F: during catalyst heating after a cold start the rail pressure overshoots its setpoint because the high-pressure pump supplies more fuel than requested or cannot be throttled back. On GM direct-injection petrol engines the measured pressure must exceed the target by 3 MPa or more, on the map it shares with P228D, for 10 s within 12.5 s (25OBDG03B; in 19OBDG03D only 2 MPa from 20 MPa desired); Type A, MIL on the first trip. GM's 2023 table 23OBDG07 trips when the filtered deviation stays below minus 3 MPa for 7 s, again one trip. Most often a quantity control valve that sticks or a drive circuit fault keeps the pump at full delivery; a drifting rail pressure sensor or software can also be responsible. Too much pressure makes cold idle harsh and noisy; outside warm-up the same fault reads P228D.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 20

Possible causes

  • Quantity control valve on the high-pressure pump stuck in the delivering position high
  • Wiring or connector fault in the control valve drive circuit medium
  • Rail pressure sensor drifting so the controller overshoots medium
  • Engine control software that needs an update low

Symptoms

  • MIL after one faulty cold start
  • Harsh, loud cold idle or ticking injectors
  • Possible reduced power or rich running smell

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C20

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication