OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C1F

Cold Start Fuel Pressure Regulator A Exceeded Control Limits - Pressure Too Low

P2C1F is the underpressure half of GM's cold-start fuel pressure check on direct-injection petrol engines: while the catalyst is being heated, measured rail pressure lags the target by more than a calibrated margin. Table 25OBDG03B uses a 3 MPa gap for desired pressures from 4 MPa up (2 MPa at 3 MPa), the same map as P228C; 10 s of failures within 12.5 s set the code as Type A, so the MIL lights after one trip. GM's 2019 table 19OBDG03D runs the same check but allows 5 MPa from 20 MPa desired, and table 23OBDG07 (2023) uses a filtered deviation above 3 MPa held for 5 s, also on one trip. Suspects are a weak high-pressure pump or quantity control valve, low feed pressure from the tank pump or a leaking injector. P228C is the same fault outside the warm-up phase, P2C20 the overpressure case.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 1F

Possible causes

  • High-pressure pump with worn plunger or sticking control valve delivering too little high
  • Low feed pressure from in-tank pump, filter or pressure regulator medium
  • Leaking or sticking injector bleeding off rail pressure low
  • Rail pressure sensor reading too low low

Symptoms

  • MIL after a single faulty cold start
  • Long cranking, rough running or stalling when cold
  • Reduced power possible if pressure stays low

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C1F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication