P2C1D
B Camshaft Profile Actuator Position Sensor C Circuit High Bank 1
P2C1D, the circuit-high code for exhaust position sensor C on bank 1, covers a feedback line pulled towards supply voltage, usually by a short to power. No carmaker publishes a use for it. On GM's L3B the matching codes P2C15 and P2C19 are evaluated with the output off, a short being declared at a resistance up to 0.5 ohm against the controller supply; there they also appear in the main list of harness chafing bulletins. With only two exhaust Hall sensors on that engine, sensor C does not exist. CARB obliges every electrical input of a lift system to be checked for out-of-range values, so a future user would likely flag this fault with a warning lamp and freeze exhaust lift switching. Inspect the wiring for contact with live circuits first.
Possible causes
- Sensor C line rubbing against a powered wire high
- Internal short to supply in the actuator medium
- Faulty driver stage in the ECM low
Symptoms
- Check engine light on
- Exhaust lift switching suspended
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C1D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.