P2C19
B Camshaft Profile Actuator Position Sensor B Circuit High Bank 1
P2C19 closes the sensor B group on the exhaust camshaft of bank 1: the feedback circuit of GM's exhaust Hall sensor 2 is shorted to a voltage source. For the L3B the ECM checks while the output is off; a path of at most 0.5 ohm to controller power, reported four times in five with supply over 11 V, gives a Type A code with the MIL on in the first trip (19OBDG03D, 25OBDG03B). P2C19 sits in the main code list of PIT5677 and 21-NA-149, which blame L3B harness damage at the camshaft carrier cover, at the base of the air cleaner box, or near the alternator bracket and the stud of the left front spring. Since no third exhaust Hall sensor exists on this engine, P2C19 is the last exhaust feedback code GM uses. Open: P2C16, ground: P2C18.
Possible causes
- Harness chafed at generator bracket or coil spring stud, line touching a live wire (GM 21-NA-149) high
- Exhaust actuator 2 shorted internally to supply medium
- ECM output stage faulty low
Symptoms
- MIL on in the first drive
- Exhaust lift switching disabled
- With extensive harness damage, stalling, no crank or blown fuses
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C19
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.