OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C18

B Camshaft Profile Actuator Position Sensor B Circuit Low Bank 1

A ground short in the position sensor B line on the bank 1 exhaust side sets P2C18. On GM's L3B this is the feedback wire of exhaust actuator 2. GM's table phrases it as a fault of the sensor's solenoid driver: with the output commanded on, a signal-to-ground impedance not above 0.5 ohm in four samples out of five, supply over 11 V and ignition in crank or run, stores Type A and switches on the MIL (19OBDG03D, unchanged in 25OBDG03B). As with P2C14, GM's PIT5677 and 21-NA-149 list P2C18 only as a keyword, not under the codes found on affected trucks. Areas to inspect include the harness run over the camshaft carrier cover and below the air cleaner box, plus the actuator connector. The second exhaust actuator stays inactive until the short is repaired.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 18

Possible causes

  • Harness insulation damaged at the camshaft carrier cover or under the air cleaner housing high
  • Exhaust actuator 2 shorted internally to ground medium
  • Water or oil bridging contacts in the plug low

Symptoms

  • MIL comes on in the first trip
  • Exhaust profile no longer changes, small rise in fuel use

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C18

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication