OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C17

B Camshaft Profile Actuator Position Sensor B Range/Performance Bank 1

P2C17 flags implausible feedback from exhaust Hall sensor 2, the position sensor of the second exhaust profile actuator on bank 1 of GM's L3B. The electrical circuit tests pass, yet the shift pattern is wrong: after a command GM expects the reading to pass below 55 (pin extending), below 45 (pin fully out) and back above 68 (pin retracted). A missing step, or a pin event reported without any command, counts as a failure; four such readings in five, with the motor turning, supply over 11 V and crank and cam sensors fault-free, lead to a Type A code, MIL straight away (19OBDG03D, 25OBDG03B). The harness bulletins only carry P2C17 in their keyword lists. Because CARB requires a single lift pin that fails to move to be caught, the engine falls back to a fixed exhaust profile. Look at oil condition and actuator 2 first.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 17

Possible causes

  • Pin of exhaust actuator 2 binding because of deposits or degraded oil high
  • Exhaust cam sleeve not snapping into its detent, worn groove medium
  • Low or aerated engine oil slowing the shift low

Symptoms

  • Warning lamp on without delay
  • Engine runs on a fixed exhaust profile, no cylinder deactivation
  • Possibly a light tapping noise from the valve train

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C17

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication