OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C16

B Camshaft Profile Actuator Position Sensor B Circuit Bank 1

P2C16 is the open-circuit fault of position sensor B on the bank 1 exhaust camshaft. On GM's L3B this is exhaust Hall sensor 2, the second and last exhaust feedback: GM's tables list four exhaust pin drivers (control codes P002A, P2B39, P03F1, P3099) but only two exhaust Hall elements, which matches the two exhaust profile actuators described by GM TechLink. The ECM energises the driver and treats 200 kilohms or more from signal to ground in four out of five samples above 11 V as an open circuit, Type A, MIL immediately (19OBDG03D, 25OBDG03B). P2C16 is part of the main DTC list of PIT5677 and 21-NA-149. Possible causes are a pulled connector, a broken wire or an open Hall element; until fixed, exhaust lift switching is disabled.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 16

Possible causes

  • Plug on exhaust actuator 2 pulled off or not locked after engine work high
  • Wire broken where the harness rubs at the camshaft carrier (GM L3B bulletins) medium
  • Open circuit in the Hall element of actuator 2 low

Symptoms

  • Check engine light in the first trip
  • Exhaust lift switching and economy modes blocked

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C16

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication