OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C14

B Camshaft Profile Actuator Position Sensor A Circuit Low Bank 1

With P2C14 the ECM reports that the line of exhaust position sensor A on bank 1 is grounded. GM applies the check on the L3B 2.7 L while the driver is commanded on: a signal-to-ground impedance of 0.5 ohm or below, seen in four of five samples with the key in crank or run and more than 11 V, sets Type A with immediate MIL; the 2025 table 25OBDG03B adds a general enable flag but keeps the limit (19OBDG03D). Unlike P2C12 and P2C15, P2C14 does not appear in the main code list of PIT5677 or 21-NA-149, only among their search keywords. Typical causes are insulation worn through on the cylinder head or the generator bracket, or a shorted actuator. The exhaust sleeves of bank 1 stay where they are; the driver mostly notices the warning lamp.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 14

Possible causes

  • Signal wire of exhaust sensor A rubbed bare against the head or a bracket high
  • Internal short to ground in exhaust actuator 1 medium
  • Engine oil wicked into the actuator plug low

Symptoms

  • MIL on immediately
  • No exhaust lift change, slightly higher consumption under light load

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C14

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication