P2C13
B Camshaft Profile Actuator Position Sensor A Range/Performance Bank 1
P2C13 is the rationality test for the first exhaust profile actuator's feedback on bank 1, so the wiring is not in question. GM's L3B tracks every exhaust shift through exhaust Hall sensor 1: the reading must drop below 55 as the pin starts to fire, below 45 when it is fully out and climb above 68 once the pin is home again. If a commanded shift does not produce these states, or the sensor reports a pin event that was never requested, four bad readings out of five with the engine running and supply over 11 V result in a Type A fault (19OBDG03D, 25OBDG03B). The test is suppressed while crank or cam position faults are active. GM names P2C13 only in the keyword index of its L3B harness bulletins. Prime suspects are a sluggish pin, sludge or a worn exhaust sleeve groove.
Possible causes
- Pin of exhaust actuator 1 slow or sticking (sludge, overdue oil change, wrong oil grade) high
- Worn shift groove or weak detent on the exhaust cam sleeve medium
- Hall element in actuator 1 delivering drifting levels low
Symptoms
- Warning lamp on at once
- Exhaust lift locked on one profile, cylinder deactivation inactive
- Occasional clicking from the top of the engine
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C13
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.