OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C0F

A Camshaft Profile Actuator Position Sensor C Circuit Low Bank 1

With P2C0F the ECM sees the position sensor C circuit of bank 1, the Hall feedback in the third intake actuator, connected to ground. In GM's L3B tables the test runs while the output is commanded on and looks for a signal-to-ground resistance not above 0.5 ohm; after 4 failures in 5 samples at more than 11 V the code is stored as Type A and the MIL lights at once (19OBDG03D; the 2025 table 25OBDG03B keeps the same limit). Of GM's harness bulletins, only the keyword section of PIT5677 and 21-NA-149 mentions P2C0F, while their main lists carry the open and high codes of this sensor. A pinched wire against the cylinder head or a shorted actuator is the probable cause; lift switching remains blocked. Open: P2C0D, high: P2C10.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 0F

Possible causes

  • Sensor C line pinched or chafed against ground high
  • Internal ground short in actuator 3 medium
  • Contaminated or damaged connector pins low

Symptoms

  • Check engine light comes on during the first drive
  • Engine no longer switches cam profile or deactivates cylinders

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C0F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication