OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C0E

A Camshaft Profile Actuator Position Sensor C Range/Performance Bank 1

P2C0E is the plausibility test for the feedback of the third intake actuator on bank 1. On the L3B, the ECM classifies each shift by the Hall signal of that actuator: extending when it drops below 55, fully extended under 45, retracted when it rises above 68 again. The code is set when a commanded shift does not produce this pattern, or when activity appears without any command. GM requires 4 faulty readings in 5 with the engine running, supply above 11 V and no active crank or camshaft sensor faults, and lights the MIL at once as Type A (19OBDG03D, 25OBDG03B). Unlike most of its siblings, P2C0E is not named in GM's harness bulletins; a mechanically sluggish actuator 3 or a damaged sleeve groove is the usual suspect. CARB demands detection of wrong-profile operation.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 0E

Possible causes

  • Pin of actuator 3 sticking or responding late high
  • Damaged groove or detent on the cam sleeve served by actuator 3 medium
  • Old or wrong-grade oil slowing the pin medium

Symptoms

  • MIL comes on immediately
  • Lift switching suspended, engine runs on one profile
  • Occasional ticking or uneven running if a sleeve sits halfway

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C0E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication