OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C0D

A Camshaft Profile Actuator Position Sensor C Circuit Bank 1

Position sensor C is the third of the Hall feedback elements on the intake side of bank 1; on GM's L3B it sits in intake actuator 3 and is named intake Hall sensor 3. That engine has four intake and two exhaust profile actuators, so a fourth intake feedback exists beyond the J2012 letters and GM handles it with P30B0 to P30B3. P2C0D is the open-circuit check for sensor C: output on, at least 200 kilohms from signal to ground, four of five samples at over 11 V, key in crank or run, Type A with MIL on the first trip (19OBDG03D, 25OBDG03B). Both PIT5677 and its successor 21-NA-149 from GM list P2C0D for 2019 to 2021 L3B trucks with chafed engine harnesses. As long as sensor C reports nothing, the ECM blocks lift changes.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 0D

Possible causes

  • Harness rubbed through over the camshaft carrier, wire broken (GM L3B bulletins) high
  • Connector on actuator 3 loose, damaged or corroded medium
  • Open circuit inside actuator 3 or its Hall element medium

Symptoms

  • Check engine light on in the first trip
  • No lift switching, no cylinder deactivation
  • Further codes, reduced power or no start if the harness is damaged

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C0D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication