OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C0B

A Camshaft Profile Actuator Position Sensor B Circuit Low Bank 1

P2C0B reports that the circuit of position sensor B, the Hall feedback of the second intake actuator on bank 1, is shorted to ground. GM's L3B 2.7 L uses it with a resistance test while the output is on: at 0.5 ohm or less from signal to ground, 4 of 5 failed samples with supply over 11 V store a Type A code and the MIL comes on immediately (19OBDG03D, 25OBDG03B). Interestingly, GM's table wording for this test speaks of the sensor's solenoid driver, so the ECM judges the line from its output stage rather than from a sensor voltage. GM lists P2C0B only among the keywords of bulletins PIT5677 and 21-NA-149 on L3B harness chafing. Possible effects: stuck lift profile, no cylinder deactivation. Open: P2C09, short to power: P2C0C.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 0B

Possible causes

  • Insulation of the sensor B line worn through against engine metal high
  • Shorted actuator 2 or its integrated Hall element medium
  • Moisture or oil in the connector low

Symptoms

  • Check engine light on straight away
  • Valve lift no longer changes, fuel use may rise

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C0B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication