OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C0A

A Camshaft Profile Actuator Position Sensor B Range/Performance Bank 1

Here the wiring of position sensor B is intact, but its report does not match what the second intake actuator on bank 1 was told to do. On the L3B, GM follows every shift through three Hall readings: below 55 while the pin is moving out, below 45 once fully out, and above 68 when it is back home. P2C0A is stored if this sequence is not seen after a command, or if the feedback shows pin activity although the ECM never asked for a shift. Four bad readings in five, engine running, more than 11 V and no crank or cam sensor codes are required; Type A, MIL at once (19OBDG03D, 25OBDG03B). A slow or sticking pin, a worn shift groove or poor oil are therefore likelier culprits than wiring. CARB requires the lift system to catch cylinders running on the wrong cam profile.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 0A

Possible causes

  • Pin of actuator 2 sticking or slow (wear, sludge, wrong oil) high
  • Worn shift groove or detent on the intake cam sleeve medium
  • Hall element in the actuator reporting implausible levels low

Symptoms

  • MIL on at once
  • Engine kept on a fixed cam profile, no cylinder deactivation
  • Possible ticking from the camshaft carrier or slightly uneven idle

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C0A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication