OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C09

A Camshaft Profile Actuator Position Sensor B Circuit Bank 1

Position sensor B belongs to the second of the four intake actuators that slide the cam sleeves on GM's L3B; GM's tables call it intake Hall sensor 2. The sensors are thus one per actuator, not one per lift step: sensors A to C get J2012 codes, while GM puts the fourth (sensor D) under its own codes P30B0 to P30B3. P2C09 is the open-circuit test for sensor B. With the output energised the ECM expects a low impedance; 200 kilohms or more between signal and ground in 4 of 5 samples, supply above 11 V, set a Type A fault (19OBDG03D, 25OBDG03B). GM bulletins PIT5677 and 21-NA-149 list P2C09 for L3B trucks with chafed harnesses. Without feedback the ECM cannot confirm shifts, so lift switching is disabled. Low and High are P2C0B and P2C0C.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 09

Possible causes

  • Loose, unplugged or corroded connector on actuator 2 high
  • Wire broken by harness chafing on the camshaft carrier (GM L3B bulletins) medium
  • Open circuit inside the actuator or its Hall element medium

Symptoms

  • Check engine light on in the first trip
  • Lift switching and cylinder deactivation locked out
  • Usually no noticeable change in driving apart from fuel use

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C09

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication