OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2C08

A Camshaft Profile Actuator Position Sensor A Circuit High Bank 1

P2C08 flags a short to voltage on position sensor A, the Hall feedback of the first intake profile actuator on bank 1. GM's L3B 2.7 L four runs this check the other way round from the ground test: the output stage is switched off, and if the line still shows 0.5 ohm or less towards controller power, 4 of 5 such readings above 11 V store a Type A code with immediate MIL (19OBDG03D, again 25OBDG03B). Unlike the ground fault P2C07, P2C08 sits in the main code list of GM bulletins PIT5677 (2019) and 21-NA-149 (2019 to 2021 Silverado and Sierra 1500), which blame engine harness damage over the camshaft carrier and near the left shock tower and mention blown fuses. Lift switching stops until the fault is cleared. Open circuit: P2C05.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberC / 08

Possible causes

  • Chafed engine harness touching a live circuit (GM bulletins PIT5677, 21-NA-149) high
  • Internal short to supply inside the actuator or its feedback element medium
  • Faulty output stage in the ECM low

Symptoms

  • MIL lit immediately
  • No valve lift change and no cylinder deactivation
  • After harness damage also rough running, reduced power or no start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2C08

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication