P2C07
A Camshaft Profile Actuator Position Sensor A Circuit Low Bank 1
On GM's 2.7 L turbo four L3B (Silverado and Sierra 1500 from 2019) each of the four intake sliding-cam actuators reports its pin travel through a Hall element; GM calls the first one intake Hall sensor 1, which is position sensor A in J2012 terms. P2C07 means this circuit is pulled to ground. The ECM checks it with the output stage switched on and treats an impedance of 0.5 ohm or less between signal and ground as a short; 4 failures in 5 samples with more than 11 V supply set a Type A code, MIL in the first trip (19OBDG03D, 25OBDG03B). GM bulletin 21-NA-149 names P2C07 only in its keyword list for chafed L3B engine harnesses. Pin feedback is lost, so lift switching and cylinder deactivation are blocked. Open circuit is P2C05, short to power P2C08.
Possible causes
- Engine harness chafed through to ground, e.g. over the camshaft carrier cover high
- Internal short to ground in the profile actuator or its Hall element medium
- Oil or water in the actuator connector bridging to ground low
Symptoms
- Check engine light on from the first drive
- Engine stays on one lift profile, no cylinder deactivation, slightly higher consumption
- With harness damage, possibly blown fuses and many further codes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2C07
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.